Fire Rebuild & Reconstruction in Reseda
Reseda fire repairs that keep water out of patched walls: new paper lapped into old, flashed penetrations and a weep screed clear of the soil.
Where new stucco meets old on a repaired Reseda wall, water looks for the seam. A fire repair leaves a seam at the edge of every patch, plus every hose bib, light fixture and pipe that passes through the patched area. We lap the new building paper into the old at each edge, flash every penetration, and finish the joint so rain runs down the face of the wall and out at its base.
Tying new paper into old
At the edge of a patch, the old stucco is cut back in a clean line to expose the existing building paper. Along the top edge the new paper tucks under the old, and along the bottom it laps over, so each piece sheds onto the one below. Metal lath overlaps the old lath and is fastened into framing. Where the old paper is too brittle to lap, a flashing membrane bridges the joint. The color coat then goes over the whole wall, so the patch blends in.
Every hole through the wall
Hose bibs, dryer and fan caps, light boxes and gas lines each break the barrier. We set a molded block or a flashing collar at each one, tape it into the paper shingle fashion, and seal the cap to the finish. Vents in the repaired wall are ember resistant units, set in their own flashing so their screens stay dry. At the base, the weep screed sits above any soil or paving so the wall can drain, which keeps water away from studs we just dried and replaced.
About our Fire Rebuild & Reconstruction serviceServices in Reseda
Fire Rebuild & Reconstruction in Reseda: common questions
We weigh char depth, how long the framing stayed wet, and the condition of the slab. Sound, dry framing over an uncracked slab favors a repair of the damaged walls. Framing that charred deep or rotted across the house favors a new build. The decision and the readings behind it come to you on paper.
Yes. Wall patching is often priced by area alone, which can leave out cutting back to sound stucco, new paper and lath, flashing at each penetration and a full color coat. We set those beside the adjuster's figures and mark the gaps, and you take the marked copy to the carrier.
For a Reseda parcel, look to the state fire hazard severity map. If it is mapped, the wildfire chapter sets rules for vents, roofing, eaves, glazing and siding. If not, standard code covers the work, and hardened parts can be added at a listed price each.
Fire Rebuild & Reconstruction in other cities
More work we do in Reseda
Plan your project in Reseda
Tell us about the house and the fire rebuild & reconstruction work. We reply about a walk-through and a written scope.