Stucco & Exterior Walls in Valley Village

Ledges, sills and joints hold water on a stucco wall. Fernhill Builders details Valley Village exteriors so water has somewhere to go.

Describe the house and the work

By sending, you agree Fernhill Builders may contact you by call, automated text or email about your request. Consent isn't required to buy. Msg & data rates may apply; reply STOP to opt out. Privacy Policy

Water sits wherever a wall offers a flat place to hold it: a sill, the cap of a low wall, a planter edge or the joint where plaster meets concrete. Those spots soak the plaster from the outside and are easy to miss. On a Valley Village job we map every flat surface and decide where its water goes.

Sills, caps and ledges

Window sills should slope away from the glass and end in a drip edge. Caps on low walls and parapets need a slope and an overhang so water drips clear of the face. Wide ledges get metal flashing set under the plaster. We sight along each one and check that rainwater runs off, then list the ones that need rebuilding. A ledge that holds a puddle will crack the plaster beneath it sooner or later. Metal drip edges are replaced where they have bent or rusted.

Joints and planters

Where stucco meets a concrete slab, a planter or a pool deck, a joint filled with flexible sealant takes up movement. Old sealant cracks and lets water behind the plaster. We cut it out, clean the joint and refill it with a sealant suited to both surfaces. A planter wall built against the house gets a waterproof layer and a drainage gap, or the planter is moved back. Hose bibs and light fixtures are sealed with flanged covers. Pool deck joints get the same treatment.

About our Stucco & Exterior serviceServices in Valley Village

Stucco & Exterior in Valley Village: common questions

Plan your project in Valley Village

Tell us about the house and the stucco & exterior work. We reply about a walk-through and a written scope.