Commercial Construction in Van Nuys
Commercial shells in Van Nuys clad in noncombustible stucco, metal or masonry, with rated walls, fire-classified roofs and code-compliant glazing.
Cement stucco over metal lath is a noncombustible wall skin, and on a commercial shell it gives a rated wall a surface that takes hard sun and dry wind without peeling away. For a Van Nuys building the cladding is chosen with the construction type in mind, since that type decides whether a wall may burn at all. Metal panels, fiber cement and masonry veneer are the other options we price.
Cladding on a rated wall
A rated wall is tested as a complete assembly, so stucco, lath, weather barrier, sheathing and framing go in exactly as the listing describes. Substituting a single layer voids the rating. Lath is fastened to the framing through the barrier, and the stucco is applied in coats, each left to cure before the next. Control joints break up large panels so shrinkage cracks follow a planned line, and trapped water leaves through a weep screed along the base. Each coat is allowed to cure before the next goes on, and the finish coat is applied in one continuous pass across a wall so the color stays even.
Roofs and glass
The roof covering carries its own fire classification, and a Class A assembly resists burning brands landing on it. Standing seam metal, concrete tile and a cap sheet membrane over a flat deck can all qualify with the right underlayment. Storefront glazing is tempered or laminated where the code asks for it, set in aluminum framing with a thermal break. Each product is checked against its listing before it is ordered, and the listings are kept in the submittal binder.
About our Commercial Construction serviceServices in Van Nuys
Commercial Construction in Van Nuys: common questions
Walls near a lot line carry a fire rating, and the cladding on them must belong to a tested assembly. Walls set farther back may take other finishes, but the construction type still limits what can burn. Roofing needs a fire classification, and glass area follows the openings the code allows. Those choices are written on the exterior sheets.
Yes. Send the permit set and we check every exterior material it calls for against the manufacturer's listing before pricing. If a specified product lacks the rating the wall needs, we tell the architect so the sheet is corrected. Where drawings do not exist yet, we can coordinate a design team.
Every material gets a line in a written scope: framing, lath and stucco, roofing, glazing and the rest of the shell. The lines come from the approved drawings, so a swap of cladding changes only its own line. We set no figure before the plans are read.
Commercial Construction in other cities
More work we do in Van Nuys
Plan your project in Van Nuys
Tell us about the house and the commercial construction work. We reply about a walk-through and a written scope.