Office & Retail Renovation in Burbank
Burbank office and shop renovations run in a set sequence: survey, permit, a sealed work area, rough-in and inspection, then storefront glass and finishes.
Measured drawings of the existing suite come before any demolition in a Burbank office or shop. Those sheets let the City of Burbank review the new layout, and the permit has to be issued before a partition is cut. Next the side that keeps trading gets a sealed dust barrier. Only then does the noisy work start, with tempered storefront glass and the finishes saved for the end, when dust is no longer flying.
Survey, drawings and the permit
The opening visit is a walk through the suite with a tape and a flashlight, noting which walls carry ceiling grid, where the electrical panel sits and which circuits feed the side that stays open. That survey becomes the existing-conditions sheet. The new layout is drawn over it, with exits, restroom access and any glass marked by type. Comments on the set come back from the city's plan review, and we answer every comment in writing. Phasing is settled while the review runs, so the dust barrier, the temporary entrance route and the noisy days are agreed with you before the permit card goes up.
Rough-in, inspection, then glass
Once the permit is posted, demolition opens the work side and framing for new partitions goes up. Electricians, data installers and plumbers run their lines while the studs are still bare, and branch ducts are moved to suit the new rooms. An inspector signs off the rough work before any drywall is hung. Storefront glass is ordered from sizes taken after the old frame comes out, then set near the end so the entrance is boarded for as little time as the work permits. Tempered glazing goes wherever the code calls for safety glass. Paint, flooring and fixtures close the job.
About our Office & Retail Renovation serviceServices in Burbank
Office & Retail Renovation in Burbank: common questions
Usually part of it can. The floor is split into phases, and the side still trading sits behind a sealed dust barrier with its own clear route from the front door. Loud tasks such as saw cutting and demolition are grouped on days agreed with you, and the phase plan is settled before the permit work starts.
Yes. Old panes, entry doors and storefront frames can all be replaced within the renovation. New glass is tempered or rated where the code requires it, and the written scope names the exact product. Sizes are taken after the old frame is out, since the opening behind it can differ slightly from the drawings.
We file it. The drawings go to the City of Burbank under our name, and our office handles the plan check comments that come back. We also meet the inspector at each stage, from rough framing and wiring through the final sign-off, so you are not left arranging visits around business hours.
Office & Retail Renovation in other cities
Plan your project in Burbank
Tell us about the house and the office & retail renovation work. We reply about a walk-through and a written scope.