Structural Work in Burbank
Burbank framing repair sequenced from shoring to closing in, with engineered beams, posts and footings, permitted by the city. Fernhill Builders.
Shoring goes up first on a Burbank structural job. Demolition follows, and new lumber or steel goes in after that. This order keeps the roof carried at every moment, so a wall can be opened without the ceiling above it dropping. Drawings come before any of it, since the city building department reviews the sequence along with the member sizes, and each stage is checked before the next begins.
Temporary support before demolition
Temporary posts and beams pick up the load of whatever is coming out, whether that is a burned stud wall, a rotted girder or a bearing wall opened to the next room. The engineer specifies where those supports bear, and the crew confirms the floor or slab beneath them can take the weight. Only then does demolition start. Old members come out a short section at a time, and each new piece is fastened before the next old one is removed. Inspections are requested at the points the drawings name, so the framing stays visible until an inspector has looked at it.
Closing in comes last
Finish work waits for the structure. Insulation, drywall, sheathing and stucco go back only after the inspector has passed the framing, the connectors and any footing work. The building department sets which inspections apply, and the permit card lists them. Plumbing and electrical lines that cross the repaired area are rerouted while the framing is still open, because moving them later means drilling fresh holes through members that were just repaired. A short punch walk follows, and then the surfaces are rebuilt over the finished frame.
Structural Work in Burbank: common questions
Start with what the surface shows: charred edges, a floor that dips between supports, a ceiling line that has dropped, or soot on the inside face of a wall. A scorched member can look healthy from outside, so we cut small inspection holes and let an engineer rule on each piece before anything is kept.
Yes, whenever fire damage or a changed load path is involved. A charred rafter or a wall coming out needs calculations the city can check. Minor repairs that follow the residential code tables might skip them, and the city's plan review tells you which route applies.
Usually, provided a beam and posts take over its load and footings below can receive them. Temporary supports carry the roof and floor during the swap. Drawings and a permit come first, and the inspector looks at each stage before it is closed in.
Structural Work in other cities
More work we do in Burbank
Plan your project in Burbank
Tell us about the house and the structural work work. We reply about a walk-through and a written scope.